Technical Details
​
â– Determination limit for type CLT-mA-0.5ppm < 0.02 mg/l
â– pH range: 6.5 … 9.5
â– Temperature: 1 … 40 °C
â– Pressure max. 1.0 bar
â– Signal outputs: CLT1-mA: 4-20 mA signal, temperature-compensated, uncalibrated, not electrically isolated; CLT1-CAN: digital, temperature-
compensated, uncalibrated, electrically isolated.
​
Chlorite Sensor CLT 1-mA
Sensor for monitoring the disinfection by-product chlorite in compliance with potable water regulations. Without cross-sensitivity towards chlorine dioxide, chlorate and chlorine. For operation on controllers with 4-20 mA input
​
Your Benefits
â– Online monitoring of the disinfection by-product chlorite
â– Diaphragm-covered sensor minimises faults caused by changing flow or ingredients in the water
â– No interference by chlorine dioxide/chlorine/chlorate
â– Online monitoring improves process reliability
â– Online monitoring replaces expensive laboratory analysis
​
Chlorite sensors complete with 50 ml of electrolyte.
Note: A mounting kit (order no. 815079) is required for initial fitting of the chlorite sensors in the in-line probe housing DLG III.
The DT4 photometer is recommended for calibration of the chlorite sensor.
​
Chlorite Sensor CLT 1-mA
Sensor for monitoring the disinfection by-product chlorite in compliance with potable water regulations. Without cross-sensitivity towards chlorine dioxide, chlorate and chlorine. For use on controllers with CAN-bus connection
​
Your Benefits
â– Online monitoring of the disinfection by-product chlorite
â– Diaphragm-covered sensor minimises faults caused by changing flow or ingredients in the water
â– No interference by chlorine dioxide/chlorine/chlorate
â– Online monitoring improves process reliability
â– Online monitoring replaces expensive laboratory analysis
â– Operation on the CAN-bus with all the associated benefits
​
